tmiggs1965
08-01-2010, 01:41 PM
Hello All,
I am new to the site and wanted to get some insite into the CPP upgrade I am doin on my 65 chevy c-10 shortbed. I installed a 67 power steering gear box, pump, etc. I had to modify my original steering shaft to accept the CPP part # CSS-LG to connect to the new rag joint. However the intermediate shaft is spinning inside the flange that bolts to the ragjoint . Anyone know the correct way to fix this?? should I weld it or drill and put a pin through it??
Any pointers would be appreciated.
Thanks!
I am new to the site and wanted to get some insite into the CPP upgrade I am doin on my 65 chevy c-10 shortbed. I installed a 67 power steering gear box, pump, etc. I had to modify my original steering shaft to accept the CPP part # CSS-LG to connect to the new rag joint. However the intermediate shaft is spinning inside the flange that bolts to the ragjoint . Anyone know the correct way to fix this?? should I weld it or drill and put a pin through it??
Any pointers would be appreciated.
Thanks!