which bore , mcpv-1

**rogertheracer** · 08-14-2010, 03:26 PM

i have a heidts front clip with 11" rotors/ 78-88 metric gm calipers and 9" ford rear drums.
which bore m/c do i need 1" or 1 1/8"? these are manual brakes.
its a 64 nova pro street with 31-18.5 x 15" rear tires.

thanks, roger

**CPPAaron** · 08-16-2010, 08:14 AM

Sounds like a nice setup! The manual brake applications like yours will use part # CP31500-C (1" bore) Whenever you use a large power booster (typically 8" dual or larger) then the 1 1/8" would be used.

**rogertheracer** · 08-16-2010, 05:54 PM

thanks aaron, is that a direct bolt on(no mods.) to my 64 nova (standard brakes) ?

**CPPAaron** · 08-17-2010, 08:10 AM

Yes, this will bolt directly to the 2 studs coming out of the firewall.

**rogertheracer** · 10-31-2010, 08:49 AM

aaron ,

in my first post (view) i indicated i had the heidts manual master cyl . 64 nova ( with gm calipers front and 9" ford drum rears . what improvement will i see by changing to the mcpv-1 master if any ?

thanks , roger

**CPPAaron** · 11-01-2010, 08:49 AM

The MCPV-1 is our All in one master... This master will allow you to adjust the proportional valve to fine tune the rear brakes.

**rogertheracer** · 01-30-2011, 01:41 PM

Aaron, I just received my MCPV1-C ( WOW IT IS NICE)
Question, I'm reading how to do the bleeding withe the syringe.(master in car)
Is this proceedure done with the brake line connected to the M/C and
with the bleeders closed ?
Please expain in more detail.

Thanks, Roger