Good Morning,
When you have no rear pressure this means you have tripped the safety feature in the valve (Full fluid travel to the front,blocking off the rear) You will need to reset the valve. This can be caused by bleeding incorrectly. You need to always start with the longest line first and work your way to the shortest line. Basically, you need to make sure the front is never cracked open to bleed before the rears are fully bleed.
http://www.classicperform.com/Instru...brakeguide.pdf
If you have any other troubles feel free to email or call me.
Aaron Strietzel
Email Aaron
Classic Performance Products Inc.
378 E. Orangethorpe Ave
Placentia, CA 92870
Visit Our Site
714/522-2000
714/522-2500 fax
Im not seeing where you reset the prop valve. And I stated from the back when I bled.
Guess I have to completly dissasemble the prop valve.
Or go though the rear port with a small paper clip and reset that way.
Aaron Strietzel
Email Aaron
Classic Performance Products Inc.
378 E. Orangethorpe Ave
Placentia, CA 92870
Visit Our Site
714/522-2000
714/522-2500 fax
http://www.classicshoptalk.com/conte...-jim-ries.html
Here is another helpful link!
Aaron Strietzel
Email Aaron
Classic Performance Products Inc.
378 E. Orangethorpe Ave
Placentia, CA 92870
Visit Our Site
714/522-2000
714/522-2500 fax
I just pulled the metering valve depressed the brakes and reinstalled the valve. Re bled and all works now.
Bookmarks