I bought the 32" floor shift model ECSC-T and was thinking it will accept a 3/4DD inside the column reciever or a 1"DD outside the reciever end, am I correct??
I bought the 32" floor shift model ECSC-T and was thinking it will accept a 3/4DD inside the column reciever or a 1"DD outside the reciever end, am I correct??
Good Morning,
We only recommend using the outer 1" DD for coupling.
Aaron Strietzel
Email Aaron
Classic Performance Products Inc.
378 E. Orangethorpe Ave
Placentia, CA 92870
Visit Our Site
714/522-2000
714/522-2500 fax
Hi
I have wired up my #ECSC-S (33 incher) with turn sigs working, but have one wire left over....
It's the single black wire with the green blade connector. (Not part of the connector-ized turn signal group)
Can you confirm where it goes?
Thanks!
Roadmaster75
That is for the indicator light.
Aaron Strietzel
Email Aaron
Classic Performance Products Inc.
378 E. Orangethorpe Ave
Placentia, CA 92870
Visit Our Site
714/522-2000
714/522-2500 fax
Hi
I have wired up my #ECSC-S (33 incher) with turn sigs working, but have one wire left over....
It's the single black wire with the green blade connector. (Not part of the connector-ized turn signal group)
Can you confirm what it's for ; where it goes?
Thanks!
Roadmaster75
Bookmarks